Recent content by PyrBliss

Blackfire Wet Diamond paint sealant. Best for black bar none and couldnt be easier to apply. I know I had a side business detailing other peoples cars for 8 years not to mention I have 3 black vehicles myself. I hate black but love it whens its clean....for 2 minutes.

Wow and seems cheap enough to do as well. I will for sure be looking into buying some. Thanks for the tip :D I wonder how drive-ability will be with these cams coupled with a blower?

Yeah I'm thinking so. It's out, might as well go through everything and start fresh.

I know. Normally I would just change them in car like you suggested. Just wondering if since the heads are coming off for the forged rod/piston install anyways, if I would be wise to have them rebuilt while I'm at it.

Should I just get them rebuilt since they will be off anyway?

Ok. So after driving my new to me MM for 2,167 miles, I have noticed that it was down almost 2 quarts of oil. Confirmed blue smoke on start up as well. After searching it seams most likely culprit is the valve guides or stem seals. My logic tells me that to solve the problem correctly, I had...

I have a 03' GM with a failing LCM. It's the winter car so need reliable headlights. PM me if your still fixing LCMs. Have no Hi/Lo beams unless I smack the dash hard.

Ah I see it now :) My apologies as this is my first time being a part of a forum. Thanks again.

No worries man. My PM's were acting goofy so wasn't sure if members were receiving my messages. Thanks fastblackmerc.

^^Do you still have an extra spring for the EATC vacuum actuator?

Fastblackmerc............ I sent you a PM but my message box says nothing was sent??? Just let me know if you get it or not. Thanks.

Sweet......Pm sent!

Just got the car. So far: Changed spark plugs Installed U-haul tranny pan Full detail inside and out Changed fuel filter Changed oil and filter Changed rear end fluid Fixed AC + EATC issues Changed PCV + thermostat (preventative) Cleaned the TB + MAF sensor

Looks solid! I did send Zack a PM regarding the cooling mod. I'm still a bit unsure what parts exactly I need as I know many kits are for the 4v stangs. Does the marauder require slightly different parts?

Update: Discovered a spring missing in one of the vacuum actuators. Not sure how I missed that when I initially replaced the O-rings. :rolleyes: Now I just have to find a new spring....