mustangeddie
Active member
The one I have is from an 04.Without clock. I have a 2004 and would like the clock. My 2003 has the clock. Can I alter and use the one with the clock?
The one I have is from an 04.Without clock. I have a 2004 and would like the clock. My 2003 has the clock. Can I alter and use the one with the clock?
Pm sent...How much do you want for it?
pm sent...Looking for the cup holder section of the center console. I have two and they are both broken at the lower points so need a completely undamaged one.
Yes it is...Is the PCM available?
I do I'll have to check if it's intact, you don't need the lid?Any chance you still have the console insert?
The dot matrix piece that goes from glovebox over to the heater control if so yes.Passenger side trim above glovebox?
Sent from my SM-A515U using Tapatalk
I have one.I'm looking for the rubber boot behind the headlight bulb on a 2003 B model. OEM was a hard plastic 1/4 turn cap. Later revisions went to a softer rubber like cap, that is what I need one of. Thank You.
Have a couple need to bead blast them to see how bad the rust is.Crossover pipe?
Sent from my SM-A515U using Tapatalk
Yes sir. Need that and passenger headlight if clear.The dot matrix piece that goes from glovebox over to the heater control if so yes.
Only p/s headlight I have has a scratch in it & is not perfectly clear can probably be buffed up by a professional.Yes sir. Need that and passenger headlight if clear.
Sent from my SM-A515U using Tapatalk
pm sent...Yea Mines can buff out too. Dot matrix trim??
Sent from my SM-A515U using Tapatalk