Recent content by Dan19063

This is me

Looking to buy a Good Condition Upper coolant cross over tube and new burp plug

If you can find a place I would be interested.

Can any one advise me as to where to get a replacement Upper and Lower coolant crossover tube. As you can see from the photos the lower tube is pretty bad. Everything is OEM as far as the engine goes.

I am not sure what a DMM is ? Would this be a Digital Multimeter? If so yes I do.

Need to install a Phillips CAN-Bus adapter for my front turn signal led's due to hyper flash issue. Does anyone know the wire color codes for positive and negative wires going to the turn signal socket. These adapters must be spliced in at that point.

Update on the plug install. OK so, did these yesterday for first time at 104,000. As you can see by one of the pics the last plug on drivers side. The plug well was full of oil. I'm guessing after some research that I'm going to need new valve cover gaskets and plug seals to remedy this...

This site is for information for people. Maybe all people who come to look for info might not be as technically savvy as others. My fault was I worded it wrong. Im not crying about it, I just think its a Lame response to a question.

I apologize if I took it wrong but, It really looked like you were trying to be. Not like you added a recommendation after your "non sarcastic" :rolleyes: reply

Yeah I know they aren't wires per say. Coil-On-Plug Connectors or whatever is that better. Were you born an :censor: or did you get a degree in it ?

Car just hit 103,000 figured time to change the stock plugs. Searched the site to see what was recommended and ordered the NGK 4177 TR6 plugs from Amazon (2 packs of 4) for $20.00 free shipping. Thought I would change the plug wires also but, I couldn't find anyone's input on replacement plug...

Hope its all good till then its running. I just wont use my cruise control till it gets here ;)

Would still like to know what the options might be for a bigger size and what else would need to be done if I did that. I still have to order a new gasket for it the one on there chipped off in spots and now when you push the throttle the engine revs and stays at a higher rev 1700 rpm for...

Thank you for your offer, but Loud2004marquis PM'd me and is sending me one.

So I was having the sticky throttle problem. I went to clean the throttle body and in the process of taking it off. The little plastic, lets call it a Nipple, broke. See attached photo for what I am talking about. I did manage to super glue the thing back on but I'm sure it will not hold for...