Recent content by PantherP71

I found what I need for another venue. Thanks to those that offered suggestions and options.

They are dumb if they aren't out of the country.

If others cut there coils that is fine with me. I, however, would rather not cut my coils.

Sometimes I like to mix in sand with it.

I always run fresh cold water from my hose inbetween draining old oil and putting in new oil.

Anybody have a link for that?

I do not want cut coils. Is there a camber bolt or part number that I will need?

Maybe I should run water through the engine between oil changes, also. You know to make sure it is cleaned out? I'm open for actual suggestions. I am not cutting springs though* Edit: Thanks Comin'

What do I need to lower my car a little. I hear guys go with 1.5" coils, what else would I need?

I don't always force memes, but when I do they are horrible.

Crabby has one on his CV.

If you think that my two posts are the only reasons this 27 page massacre should be locked. You need to rethink that.

Everyone knows you measure from the base of the balls to the tip of the shaft. Hard.