Search results

You guys are awesome! Thank you thank you . I will get on it today. Replace Tstat and burp my system. So far I’ve replace a fuel pump without dropping the tank and did the O ring fix for my EATC system thanks to this forum. I will pay it forward with every remedy. Thanks again. Sent from...

Thanks I will do it today also I’m going to replace the autozone Tstat with the Napa Thm 109 Thanks again Sent from my iPhone using Tapatalk

Sent from my iPhone using Tapatalk

Hello all I have changed out my radiator water pump and thermostat my 03 marauder is overheating! Almost immediately the temp gauge shoots up and water is not circulating to the top hose. Pleeez help! Sent from my iPhone using Tapatalk

I need the passenger side fog light assembly Sent from my iPhone using Tapatalk

Hello Marauder Friends, First and foremost thank you all for your contributions and willingness to assist. I have replaced the thermostat in my 03 Marauder twice and each thime my temp gauge is about 1/4 from reading in the red. I see no sign of water pump leak, or hose leaks. What can...

Thank you sooooo much ! I was told by a local garage 2 years ago it was the actuator door. They were going to charge me nearly 500.00. I followed your suggestions and my cousin and I was able to fix the problem by changing out the 4 o rings. It didn’t matter Orelieys sells them for a dollar a...

Thank you Sent from my iPhone using Tapatalk

You’re absolutely right I put the dimples in the hat and then tighten up. Installed thanks for your promptness Sent from my iPhone using Tapatalk

Hello I have replaced the fuel pump (without dropping the tank) and going back with tank seal/ gasket and the tank hat. I cannot get the seal/gasket to stay in place. Sent from my iPhone using Tapatalk

Hello everyone had a small deer run out in front of me and it took out my passenger side fog light. In need of one as I want to keep the original look I also need the plug or connector just the naked wire Sent from my iPhone using Tapatalk

03 MM, Hello And greetings to everyone I’ve just replaced a fuel pump without dropping the tank and I am almost done my only problem is keeping the fuel gasket seal to stay in place while I bolt the outer plate up. Any suggestions or tips on getting the seal to stay in place Thanks in advance...