Now Swapped with the TVS 2.65!

F

Fordtech7

New member
So, I ditched the 20 yr old blower from the terminator as I found out no matter what parts were replaced in it the backlash or lash just wouldn’t go away. It was a rattle trap. So I took the risk of trying the 2.65 L GEN 3R blower intended for Termi Cobras from VMP and I’m very pleased with fitment and the product so far. FYI, I haven’t had to make a single modification to the car for fitment during the install but the fuel rails may need work. How much depends on your rail system of choice. I will note that I have the stainless COT from Mr Irwin I believe and it’s perfect for this blower as well! Big smile on my face finding out it all fits like factory and removal is a piece of cake! I’m getting ready to install the 80 lb injectors, new slot MAf and write a new calibration as time permits. Figured some of you Power Adder guys my like an update about this…
 

Attachments

  • BA6FE7E5-0CB9-4FA3-A2DF-2FD591559B7C.jpg
    BA6FE7E5-0CB9-4FA3-A2DF-2FD591559B7C.jpg
    208.3 KB · Views: 56
Very nice! What kind of boost are you looking to run?


Sent from my iPhone using Tapatalk Pro
 
Currently pullied for 18 lbs but I may change that. I’d like to see what power it can make at 14 lbs. The lower compression short block should handle it though.
 
I'm making 20psi on a gen1 TVS, Terminator iron block, and 60lb injectors. TVS superchargers can make 26psi easy

Low boost is where you want a TVS so 14psi is a good starting point
 
You must log in or register to reply here.
Back
Top