For Sale Nu-NRG part out

Status
Not open for further replies.
Hi,

Do you have the rear air springs? I could use them complete with solenoids, the mounting clips, the air lines up to where it goes into the frame.

I am in Yonkers, 10701. If you have them please let me know how much you need to get for them.

Thanks,
Jay
 
Hi,

Do you have the rear air springs? I could use them complete with solenoids, the mounting clips, the air lines up to where it goes into the frame.

I am in Yonkers, 10701. If you have them please let me know how much you need to get for them.

Thanks,
Jay

Hi Jay, I still have the rear air springs, however I am debating about keeping them for my next Marauder. These are parts that have a tendency to go out so I may want to hold on to them

That being said, I have yet to get to the suspension/rear end of this part out. I'm still in the interior/trunk area. Once I get to the rear end, and I am taking off the air bags, I will let you know if I change my mind. Thanks,
 
I could use the factory radio if you still have it.

Still have it if you're interested

how about the A/C compressor for sale how much shipped to 60453 ?? thanks

No one has spoken for it yet so it's yours if you want it. I will have to get back to you on the shipping since it's still on the car and I won't be getting over to take off more parts until next weekend.
 
What kind of shape is the carpet in? I thought you weren't selling the gears (your first post) thats why I didnt ask. Oh well, second dibs if toolbox107 bows out. How about the carrier assembly, is that in good shape? Is it setup for stock axles or 31 spline? One last thing, did the chin spoiler survive?

edit: Also looking for the cover that sits right below the wipers (I can see it in one of your photos), the vented one that runs the entire width of the windshield. Mine has cracked at several of the screw holes. If yours is intact and you would be willing to sell, I am very interested.
 
Last edited:
What kind of shape is the carpet in? I thought you weren't selling the gears (your first post) thats why I didnt ask. Oh well, second dibs if toolbox107 bows out. How about the carrier assembly, is that in good shape? Is it setup for stock axles or 31 spline? One last thing, did the chin spoiler survive?

edit: Also looking for the cover that sits right below the wipers (I can see it in one of your photos), the vented one that runs the entire width of the windshield. Mine has cracked at several of the screw holes. If yours is intact and you would be willing to sell, I am very interested.

Carpet is in great shape. The trunk carpet has already been spoken for but interior carpet is still avail.

Sorry about the confusion on the gears. The reason I mentioned in my first post that I wasnt going to sell them was because I wasn't sure if I was going to need them for my next Marauder (if I ended up with a Marauder with stock 3.55 gears I was going to replace with my 4.10s)

The set up (i believe) was for stock 28 spline. I don't know what condition the carrier assembly is, havent gotten to the gears during the part out yet! Lol

No one has asked for the vent cover yet but I will inspect it & try to get some pictures for you. The Mach 1 chin spoiler survived, a couple people have already expressed interest in it though..

Sent from my handheld Zack Morris iShoe 4S.
 
MM engine.

Hi Ryan, check the date on your PM's correct me if I'm wrong, but I thought I had first dibs on the engine.........Brian........aka Bruce Wayne
 
If you still have the connector and the wiring for the center clock that fits inthe dot matrix trim let me know. i have the trim and a clock but no connector/wire

Thanks
 
I need a fog light bracket, hood bolts that secure the hinges to the hood, 1 grille nut, and the hood bumpers that are on the radiator support shipped to 01569.
 
Status
Not open for further replies.
Back
Top